When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Make sure your ESCs are properly set up to reflect the state of the sliders

Make sure your motors spin up reliably on arm and in the correct direction

Make sure you've taken the propellers OFF before doing anything on this tab

Make sure you are using the latest firmware Betaflight X or newer

Make sure to update the Lua script on your radio

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

Setting volume of the beacon too high might damage the motors

Setting volume of the startup beeps too high might damage the motors

The amount of available ESCs does not match what the flight controller is reporting

proportional–integral–derivative controller (PID controller / three-term controller)

Read the release notes to understand what changed and what you might need to adjust

Enumerates a list with the ESCs/motors that are failing

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

Your flight controller does not have a compatible dataflash chip available

Your flight controller does not have an integrated BetaFlight OSD

Your flight controller isn't responding to OSD commands

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Your flight controller's firmware is too old to support this tab

select a motor output protocol appropriate for your ESCs

Welcome to ESC - Configurator, a utility designed to simplify updating and configuring of your ESCs

Time to stay in landing mode until the motors are turned off and the craft is disarmed

you are / I read you…

Only flash firmware if you are fully aware what you are doing.

You need to connect before you can view any of the tabs

Set this option to X and your receiver will work with flight controllers

Flight controller set Profile X

This method allows you to flash your receiver or transmitter

You can select here the band for your VTX

You can select here the channel for your VTX