Make sure your ESCs are properly set up to reflect the state of the sliders

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Make sure to update the Lua script on your radio

Make sure your motors spin up reliably on arm and in the correct direction

Always check that your Failsafe is working properly!

Make sure you've taken the propellers OFF before doing anything on this tab

Make sure you are using the latest firmware Betaflight X or newer

select a motor output protocol appropriate for your ESCs

Welcome to ESC - Configurator, a utility designed to simplify updating and configuring of your ESCs

Enable Sliders

use numeric input for numbers instead of sliders

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

Normally, a board will not work properly unless custom defaults are applied

not properly shielded

Set this option to X and your receiver will work with flight controllers

your rates will be set to a default curve

end-state (end state)

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

sure-kill capability

sure-kill weapon

Sure

3D mode (for use with reversible ESCs)

All ESCs

Connect power to the ESCs

Done reading ESCs

Enable 3D mode for use with reversible ESCs

Enumerates a list with the ESCs/motors that are failing

Failed reading ESCs

Flash All ESCs

same melody will be used on all ESCs

The amount of available ESCs does not match what the flight controller is reporting

The web application supports ESCs running BLHeli for Atmel, BLHeli for SiLabs and BLHeli_S.