Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

You need to connect before you can view any of the tabs

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

you are / I read you…

Only flash firmware if you are fully aware what you are doing.

You can't do this right now ...

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

can-for-can method

Atitude Mode (A Mode / Atti Mode )

document hardware on which you have successfully flashed and tested Bluejay by (adding it to the Wiki)

You don't have write permissions for this file

This can have multiple reasons

video output (VOut)

auto-tracking mode

Mass storage mode can not be activated because the storage device is not ready

expected degree of destruction

expected failure

Invalid image size (width x height) (expected...)

STM32 Communication failed, wrong response, expected 1 (0x2) received 3 (0x4)

Motor Test Mode is disabled until the settings have seen saved

video mode

Switch the VTX into pit mode (low output power, if supported)

then year

heavier then air (HTA)

Resets all motor spin directions, then allows the user to choose which to reverse

Supplied image is larger then flash available on the chip!

then apply

Can be set via the ‘pilot_name’ CLI variable

camera field of view (camera FOV)

camera change mode