This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

This method allows you to flash your receiver or transmitter

Only flash firmware if you are fully aware what you are doing.

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

track while scan / track-while-scan (TWS)

using an STLink programmer connected to the device

Make sure you are using the latest firmware Betaflight X or newer

you are / I read you…

You need to connect before you can view any of the tabs

passthrough flashing

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

You must update your device's webview in order to use the configurator

Enables motor output and allows the craft to fly

Resets all motor spin directions, then allows the user to choose which to reverse

glide path transmitter / glide-path transmitter

flash to bang / flash-to-bang (time)

flash-ranging (location), flash-spotting

Plug in your FC to your computer, but do NOT connect to betaflight configurator

pivotally connected / journaled

range while search (RWS)

connected vessels

law of connected vessels

law of equilibrium in connected vessels

maintenance while in preservation

simply connected region

neglect while on guard

service- connected disability

service-connected

firing while moving

Camera Connected