This method allows you to flash your receiver or transmitter

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

Only flash firmware if you are fully aware what you are doing.

Your receiver has just recovered from receiver failsafe but the arm switch is on

you are / I read you…

You need to connect before you can view any of the tabs

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

You must update your device's webview in order to use the configurator

Plug in your FC to your computer, but do NOT connect to betaflight configurator

Enables motor output and allows the craft to fly

Resets all motor spin directions, then allows the user to choose which to reverse

Set this option to X and your receiver will work with flight controllers

glide path transmitter / glide-path transmitter

flash to bang / flash-to-bang (time)

flash-ranging (location), flash-spotting

man-packed receiver-transmitter

portable receiver-transmitter

UHF radio receiver transmitter (RRT)

receiver-transmitter

universal asynchronous receiver-transmitter

universal synchronous asynchronous receiver-transmitter

Universal Asynchronous Receiver / Transmitter (UART)

did you copy?

do you copy?

how do you read me?

I read you loud and clear

out to you

as you were

As you were, sir / ma'am!