Your flight controller's firmware does not support transponder functionality

Your flight controller's firmware does not support Blackbox logging

Your flight controller does not have a compatible dataflash chip available

Your flight controller does not have an integrated BetaFlight OSD

The amount of available ESCs does not match what the flight controller is reporting

Your flight controller's firmware is too old to support this tab

Plug in your FC to your computer, but do NOT connect to betaflight configurator

proportional–integral–derivative controller (PID controller / three-term controller)

target does not develop

Flight controller firmware has to support this feature.

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Your flight controller isn't responding to OSD commands

File name not found in hex file, check your hex file version!

Not matching MCU type, check your hex file!

Mass storage mode can not be activated because the storage device is not ready

Prearm switch is not activated or prearm has not been toggled after disarm

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

This operation is not supported by your hardware

Your device seems to be not compatible

terminal attack controller (TAC) (= forward air controller)

Firmware image contains addresses not found on target device

Firmware not loaded

Flashing inappropriate firmware may damage your ESC

Serial port configurations of firmware is not supported

Non - Betaflight firmware is not supported, except for CLI mode

Select firmware version for your board

Select the correct firmware appropriate for your board

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

Set this option to X and your receiver will work with flight controllers

Select your flight controllers serial device below

flight controller (FC)

Beep when flight controller is powered from USB