You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

You need to connect before you can view any of the tabs

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

You will always find the latest stable version here

Latest Drivers can be downloaded from (here)

The Betaflight wiki can be found <a "docs/wiki" >here

Write your command here

you are / I read you…

Only flash firmware if you are fully aware what you are doing.

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

You can't do this right now ...

can-for-can method

This defines the number of power levels supported by your VTX

This method allows you to flash your receiver or transmitter

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

You must update your device's webview in order to use the configurator

select a motor output protocol appropriate for your ESCs

Select firmware version for your board

Select or auto-detect your board

Select the correct firmware appropriate for your board

select your desired device options

Select your flight controllers serial device below

Plug in your FC to your computer, but do NOT connect to betaflight configurator

rotating band / driving band

Click here

video transmitter (VTX)

Current VTX channel and power

Disable the control of VTX settings

Error while loading the VTX Config file

Error while saving the VTX Config file