Read the release notes to understand what changed and what you might need to adjust

You need to connect before you can view any of the tabs

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

you are / I read you…

Betaflight documentation is available in release notes and wiki

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Release notes

Show release notes on

I read you loud and clear

You need to connect first

how do you read me?

do you read me?

Only flash firmware if you are fully aware what you are doing.

understand the risks

Voltage and/or amperage meter sources have been changed but not saved

Release And Release Candidate

Values above X might damage motor and/or ESC

Failsafe configuration has changed considerably

Port changed

tension release action mine / tension-release action mine

Setting volume of the beacon too high might damage the motors

Setting volume of the startup beeps too high might damage the motors

data might not have been written correctly

flashing might fail, especially on highly integrated AIOs

updating might fail

Will additionally print addresses that are being read/written to and the sent/received payload

document hardware on which you have successfully flashed and tested Bluejay by (adding it to the Wiki)

adjust fire

adjust to a standard

Joint Urgent Operational Need (JUON)

adjust fire mission

adjust fire on enemy

Statement of Operational Need (SON)