Your flight controller's firmware is too old to support this tab

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Shows GPS info, if proper activated in Ports tab, Configuration Tab and GPS tab

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

proportional–integral–derivative controller (PID controller / three-term controller)

Flight controller firmware has to support this feature.

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Your flight controller does not have a compatible dataflash chip available

Your flight controller does not have an integrated BetaFlight OSD

Your flight controller isn't responding to OSD commands

System load is too high for safe flight

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

old army buddies

come the old soldier

decades-old

terminal attack controller (TAC) (= forward air controller)

Flashing inappropriate firmware may damage your ESC

Select firmware version for your board

Select the correct firmware appropriate for your board

target of opportunity (TOO)

Arming too soon after power on

Setting volume of the beacon too high might damage the motors

Setting volume of the startup beeps too high might damage the motors

Throttle channel is too high

Set this option to X and your receiver will work with flight controllers

Select your flight controllers serial device below

flight controller (FC)

Beep when flight controller is powered from USB

Bind request sent to the flight controller

Flight controller info