Make sure your motors spin up reliably on arm and in the correct direction

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Make sure to update the Lua script on your radio

Make sure your ESCs are properly set up to reflect the state of the sliders

Motors will spin when setting the direction!

Make sure you've taken the propellers OFF before doing anything on this tab

Make sure you are using the latest firmware Betaflight X or newer

Don't spin the motors when armed

Motors will spin when selected!

The motors will spin up immediately when selected!

The motors will spin up!

Start / spin motors

Choose the correct ‘Channel Map’ for your radio

Select the correct firmware appropriate for your board

Set motor spin direction by selecting and spinning each motor individually

run reliably

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

change spin direction

Limits power when starting motors or reversing direction

Your receiver has just recovered from receiver failsafe but the arm switch is on

set the correct meter sources and save them before trying to calibrate

sure-kill capability

sure-kill weapon

Sure

Time to stay in landing mode until the motors are turned off and the craft is disarmed

correct…

correct contact mark

correct speed

weight to correct weight

correct landing

quick correct plug-in

all correct