Setting volume of the startup beeps too high might damage the motors

Setting volume of the beacon too high might damage the motors

The volume of the startup beeps

This sets if the TX only beeps one-time versus playing a startup song

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Use Dshot beacon (use motors to sound beeps when disarmed)

Warning beeps when board is armed with motors off when idle (repeats until board is disarmed or throttle is increased)

Values above X might damage motor and/or ESC

System load is too high for safe flight

Throttle channel is too high

Motors will spin when setting the direction!

target of opportunity (TOO)

Arming too soon after power on

Your flight controller's firmware is too old to support this tab

high volume of effective fire

high-volume production

Read the release notes to understand what changed and what you might need to adjust

data might not have been written correctly

flashing might fail, especially on highly integrated AIOs

updating might fail

Maximum Startup Power (Protection)

Minimum Startup Power (Boost)

My startup melody

This value is used to adjust sinusoidal startup speed

Sinusoidal Startup

Startup Beep

Startup Power

startup sound editor

The amount of throttle in percent used for sinusoidal startup

This sets if the TX shall stay quiet on startup

Beeps SOS when armed and TX is turned off or signal lost

Beeps sound

Beeps when gyro has been calibrated