Your flight controller does not have an integrated BetaFlight OSD

Your flight controller does not have a compatible dataflash chip available

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Plug in your FC to your computer, but do NOT connect to betaflight configurator

The amount of available ESCs does not match what the flight controller is reporting

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

Your flight controller isn't responding to OSD commands

proportional–integral–derivative controller (PID controller / three-term controller)

target does not develop

Battery/Amperage/Voltage configurations using API 1.33.0 (Betaflight release = 3.17) is not supported.

Non - Betaflight firmware is not supported, except for CLI mode

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Your flight controller's firmware is too old to support this tab

data might not have been written correctly

Voltage and/or amperage meter sources have been changed but not saved

File name not found in hex file, check your hex file version!

Not matching MCU type, check your hex file!

Mass storage mode can not be activated because the storage device is not ready

Prearm switch is not activated or prearm has not been toggled after disarm

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

This operation is not supported by your hardware

Your device seems to be not compatible

modular integrated display and sight helmet (Modular Integrated Display-And-Sight Helmet)

terminal attack controller (TAC) (= forward air controller)

Betaflight documentation is available in release notes and wiki

Use Betaflight to enable the improved configuration panel

MSP connection is active with this Betaflight Configurator

no official Betaflight target was found

The Betaflight wiki can be found <a "docs/wiki" >here

Make sure you are using the latest firmware Betaflight X or newer

Set this option to X and your receiver will work with flight controllers