select a motor output protocol appropriate for your ESCs

Select the correct firmware appropriate for your board

There is no motor output protocol selected

Make sure your ESCs are properly set up to reflect the state of the sliders

Welcome to ESC - Configurator, a utility designed to simplify updating and configuring of your ESCs

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Select ESC Protocol

Select firmware version for your board

Select or auto-detect your board

select your desired device options

Select your flight controllers serial device below

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

appropriate factor

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

ESC/Motor protocol

Motor Protocol

motor output

Enables motor output and allows the craft to fly

Motor Output Limit

Shows a graph of the output of each motor

Set motor spin direction by selecting and spinning each motor individually

3D mode (for use with reversible ESCs)

All ESCs

Connect power to the ESCs

Done reading ESCs

Enable 3D mode for use with reversible ESCs

Enumerates a list with the ESCs/motors that are failing

Failed reading ESCs

Flash All ESCs

same melody will be used on all ESCs