Select your flight controllers serial device below

Set this option to X and your receiver will work with flight controllers

select your desired device options

Select the correct data format from the drop-down, below

Reset device options to the recommended defaults on this device target. Except for your custom binding phrase

Select Serial Port

select the correct serial port

select valid serial port

select a motor output protocol appropriate for your ESCs

Select firmware version for your board

Select or auto-detect your board

Select the correct firmware appropriate for your board

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

International Federation of Air Traffic Controllers’ Association

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

Device Select Error

Manual serial device selection

Outboard serial logging device

Serial device

Available applications on your device

You must update your device's webview in order to use the configurator

Your device seems to be not compatible

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Your flight controller does not have a compatible dataflash chip available

Your flight controller does not have an integrated BetaFlight OSD

Your flight controller isn't responding to OSD commands

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Your flight controller's firmware is too old to support this tab