You must update your device's webview in order to use the configurator

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

Try to search other ways to update your webview

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

Show update notifications for unstable versions of the configurator

Do you really want to close the configurator?

Welcome to Betaflight - Configurator, a utility designed to simplify updating, configuring and tuning of your flight controller

Welcome to ESC - Configurator, a utility designed to simplify updating and configuring of your ESCs

do you want update now?

Update is being downloaded, you will be notified when it is ready to install.

use dedicated configurator

you are / I read you…

Only flash firmware if you are fully aware what you are doing.

You need to connect before you can view any of the tabs

Make sure to update the Lua script on your radio

Reset device options to the recommended defaults on this device target. Except for your custom binding phrase

This method allows you to flash your receiver or transmitter

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

Device Firmware Update (DFU)

Use Dshot beacon (use motors to sound beeps when disarmed)

incompatible webview

No webview application installed / enabled

webview

accelerometer must be enabled

Must contain green, black and white pixels

Size must be X pixels

The channels must be specified with the CLI variable 'osd_rcchannels'

UART for the receiver must be set to ‘Serial Rx’

Available applications on your device