Select the correct firmware appropriate for your board

select a motor output protocol appropriate for your ESCs

Select firmware version for your board

Select or auto-detect your board

Select the correct data format from the drop-down, below

select the correct serial port

Choose the correct ‘Channel Map’ for your radio

Make sure your motors spin up reliably on arm and in the correct direction

select your desired device options

Select your flight controllers serial device below

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

appropriate factor

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

select a firmware version first

Select Firmware

Flashing inappropriate firmware may damage your ESC

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Your flight controller's firmware is too old to support this tab

Choose a Firmware / Board

Query board information to preselect right firmware

on-board digital computer / on-board computer

Warning beeps when board is armed with motors off when idle (repeats until board is disarmed or throttle is increased)

correct…

correct contact mark

correct speed

weight to correct weight

correct landing

quick correct plug-in