Non - Betaflight firmware is not supported, except for CLI mode

Battery/Amperage/Voltage configurations using API 1.33.0 (Betaflight release = 3.17) is not supported.

Serial port configurations of firmware is not supported

Mass storage mode can not be activated because the storage device is not ready

Plug in your FC to your computer, but do NOT connect to betaflight configurator

Your flight controller does not have an integrated BetaFlight OSD

Make sure you are using the latest firmware Betaflight X or newer

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

Atitude Mode (A Mode / Atti Mode )

is not supported

is not yet supported

Layout revision is not yet supported

This operation is not supported by your hardware

CLI mode detected

CLI mode

requires supported ESC firmware

Currently the following firmware are supported

except in personal self-defence

Reset device options to the recommended defaults on this device target. Except for your custom binding phrase

Prearm switch is not activated or prearm has not been toggled after disarm

Only MULTI mode currently supported

Switch the VTX into pit mode (low output power, if supported)

Firmware image contains addresses not found on target device

Firmware not loaded

Your flight controller's firmware does not support Blackbox logging

Your flight controller's firmware does not support transponder functionality

Device Firmware Upgrade Mode

via the Devices Firmware Upgrade mode

Betaflight documentation is available in release notes and wiki

Use Betaflight to enable the improved configuration panel

MSP connection is active with this Betaflight Configurator

no official Betaflight target was found

The Betaflight wiki can be found <a "docs/wiki" >here