Mass storage mode can not be activated because the storage device is not ready

Activate Mass Storage Device Mode

Prearm switch is not activated or prearm has not been toggled after disarm

Mass Storage Mode

can-for-can method

Atitude Mode (A Mode / Atti Mode )

blade flapping (the vertical movement in its plane of rotation because of differences in lift between the advancing and retreating blades)

when GPS Rescue is not available and cannot be activated

Paralyze mode has been activated

Warns when flip over after crash mode is activated

when Launch Control mode is activated

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

virtual mass / additional mass

Ready Mode

Non - Betaflight firmware is not supported, except for CLI mode

Device ready

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Firmware image contains addresses not found on target device

Your device seems to be not compatible

pressure-activated AT mine

smart target-activated fire-and-forget projectile (STAFF proj)

command activated IED

time activated IED

laser-activated silicon controlled rectifier

light-activated silicon switch

laser-activated silicon switching

activated mine

Shows GPS info, if proper activated in Ports tab, Configuration Tab and GPS tab