out to you

you are / I read you…

Only flash firmware if you are fully aware what you are doing.

You need to connect before you can view any of the tabs

You need to upgrade your firmware to the latest version of Betaflight before you can use the X tab

wait out / wait-out

did you copy?

do you copy?

how do you read me?

I read you loud and clear

as you were

As you were, sir / ma'am!

do you read me?

As you were!

Do you really want to close the configurator?

do you want update now?

Failed to write to the file you selected

Make sure you've taken the propellers OFF before doing anything on this tab

Read the release notes to understand what changed and what you might need to adjust

Do you want to apply the custom defaults for this board?

document hardware on which you have successfully flashed and tested Bluejay by (adding it to the Wiki)

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

This method allows you to flash your receiver or transmitter

Make sure you are using the latest firmware Betaflight X or newer

Update is being downloaded, you will be notified when it is ready to install.

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

You can't do this right now ...

You can select here the band for your VTX

You can select here the channel for your VTX

You can select here the frequency for your VTX if it is supported

You don't have write permissions for this file

You must update your device's webview in order to use the configurator