Switch the VTX into pit mode (low output power, if supported)

This defines the number of power levels supported by your VTX

You can select here the frequency for your VTX if it is supported

Atitude Mode (A Mode / Atti Mode )

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

Non - Betaflight firmware is not supported, except for CLI mode

Only MULTI mode currently supported

Switch off LED STRIP output

Frequency at which the Pit Mode changes when enabled

Pit mode

Pit Mode frequency

bus-tie switch; bus tie switch

ATR switch (anti-transmit-receive switch)

selector lever, fire selector, fire switch, fire selector switch

momentary switch; push-switch

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

Current VTX channel and power

VTX power

switch mode

power output

full-power output

output power

engine capacity / engine power, engine output

Reboot into boot loader / DFU mode

starting power switch

master power switch   

vehicle master power switch

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

Sine Mode Power