Connect power to the ESCs

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

3D mode (for use with reversible ESCs)

All ESCs

Done reading ESCs

Enable 3D mode for use with reversible ESCs

Enumerates a list with the ESCs/motors that are failing

Failed reading ESCs

Flash All ESCs

Make sure your ESCs are properly set up to reflect the state of the sliders

same melody will be used on all ESCs

select a motor output protocol appropriate for your ESCs

The amount of available ESCs does not match what the flight controller is reporting

The web application supports ESCs running BLHeli for Atmel, BLHeli for SiLabs and BLHeli_S.

There are simply not more ESCs connected

Trying to read ESCs

Welcome to ESC - Configurator, a utility designed to simplify updating and configuring of your ESCs

connect-disconnect action

through-connect command

Auto-Connect

Auto-Connect Disabled

Auto-Connect Enabled

click Connect button on its own

configurator automatically tries to connect when new port is detected

Flash on connect

Plug in your FC to your computer, but do NOT connect to betaflight configurator

Reopen last tab on connect

allow Wi-Fi enabled hardware to connect to the home network automatically

triggering flash on connect

You need to connect before you can view any of the tabs

You need to connect first

connect

high-power illuminator radar / high power illuminating radar (HIPIR)