Only MULTI mode currently supported

interface currently supported

Currently the following firmware are supported

Atitude Mode (A Mode / Atti Mode )

interact with character mode files only

Return altitude (meters) - only applies in Fixed Altitude mode

Non - Betaflight firmware is not supported, except for CLI mode

Switch the VTX into pit mode (low output power, if supported)

Joint Airborne Multi-sensor Multi-mission System (JAMMS)

Currently active adjustment range setting and value

currently flashed firmware is mistagged!

The craft is currently calibrating

Wipes all configuration data currently stored on the board

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

For Official Use Only (FOUO)

eyes only

night only computer generated image

FEDCON (Federal Employees and Contractors only)

double-action only

once-only approach

admittance by authorized credentials only

Core Only

electrically erasable programmable read-only memory (EEPROM)

Failsafe only

Hexadecimal digits only, 0-9, A-F

Only arm after successfull EDT handshake

Only flash firmware if you are fully aware what you are doing.

RP (increment only)