CLI mode detected

CLI reboot detected

Atitude Mode (A Mode / Atti Mode )

CLI mode

Non - Betaflight firmware is not supported, except for CLI mode

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

detected error

Configuration changes have been detected

configurator automatically tries to connect when new port is detected

Configurator has successfully detected and verified the board

Configurator has detected the board

detected

Detected device with total flash size X

gyro was not detected

No valid receiver signal is detected

Not detected

The following problems with your configuration were detected

triggered by newly detected serial port

Your radio has been detected to be on!

command line interface (CLI)

Advanced CLI AutoComplete

CLI (Command Line Interface)

CLI errors

CLI is active

Hide CLI

OSD profile name as set in the CLI variables

Can be set via the ‘pilot_name’ CLI variable

CLI variable