Always check that your Failsafe is working properly!

Make sure your ESCs are properly set up to reflect the state of the sliders

Your receiver has just recovered from receiver failsafe but the arm switch is on

Plug in your FC to your computer, but do NOT connect to betaflight configurator

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

Blink always

Normally, a board will not work properly unless custom defaults are applied

Settings can always be adjusted when offline

not properly shielded

You will always find the latest stable version here

check your internet connection

File name not found in hex file, check your hex file version!

Not matching MCU type, check your hex file!

spot check (spot- check)

Failsafe

failsafe settings

Delay for turning off the Motors during Failsafe

Enter failsafe stage X manually

Failsafe configuration has changed considerably

Failsafe is active

Failsafe Kill Switch

Failsafe Mode

Failsafe only

Failsafe Switch

Failsafe Switch Action

Failsafe Throttle Low Delay (seconds)

setup Failsafe in Modes Tab

Period of time in Stage 1 failsafe after signal loss (seconds)

Receiver failsafe

Failsafe Procedure

Warns when failsafe occurs

Hold your fire!

send your message