Failsafe configuration has changed considerably

Your receiver has just recovered from receiver failsafe but the arm switch is on

Configuration has been applied

Port changed

Read the release notes to understand what changed and what you might need to adjust

Voltage and/or amperage meter sources have been changed but not saved

Failsafe

failsafe settings

Always check that your Failsafe is working properly!

Delay for turning off the Motors during Failsafe

Enter failsafe stage X manually

Failsafe is active

Failsafe Kill Switch

Failsafe Mode

Failsafe only

Failsafe Switch

Failsafe Switch Action

Failsafe Throttle Low Delay (seconds)

setup Failsafe in Modes Tab

Period of time in Stage 1 failsafe after signal loss (seconds)

Receiver failsafe

Failsafe Procedure

Warns when failsafe occurs

hardened aircraft shelter (HAS)

in the period in which the communications channel has been open

rank has its privilege

Beep when armed and RC smoothing has not initialized filters

Beeps when gyro has been calibrated

Configurator has successfully detected and verified the board

Configurator has detected the board

required number of satellites has not been fixed

Flight controller firmware has to support this feature.

Paralyze mode has been activated