Fixed duty cycle level to be used when using sine mode

Sine Mode Power

Sine Mode Range

Atitude Mode (A Mode / Atti Mode )

When using the manual user-defined mode, the cloud binaries cache is disabled, resulting in much longer build times

adjourn sine die

limited duty cycle

duty cycle

high duty cycle radar

pulses duty cycle

higher duty cycle for transmission

Maximum amount of braking applied (complementary PWM duty cycle)

Return altitude (meters) - only applies in Fixed Altitude mode

duty, off duty

duty, on duty

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

fixed pressure level

self-level mode

call for fire using `snail` grid reference

anti-aircraft fire using fire control equipment

on the verge of using nuclear weapons

3D model generation using the 3D graphics editor

determination of bevel spatial orientation using the binary criterion

Battery/Amperage/Voltage configurations using API 1.33.0 (Betaflight release = 3.17) is not supported.

This method allows you to flash your module while it is connected to your transmitter by using the passthrough feature

using an STLink programmer connected to the device

using the bootloader on the device

Make sure you are using the latest firmware Betaflight X or newer