set via the CLI variable

Can be set via the ‘pilot_name’ CLI variable

CLI variable

The channels must be specified with the CLI variable 'osd_rcchannels'

OSD profile name as set in the CLI variables

Set the expected video mode of the camera (typically this can be left on AUTO, if you have difficulties then set this to match the camera output)

command line interface (CLI)

Advanced CLI AutoComplete

CLI (Command Line Interface)

CLI errors

CLI is active

CLI mode detected

CLI reboot detected

Hide CLI

CLI mode

Non - Betaflight firmware is not supported, except for CLI mode

Show CLI

track-via-missile (TVM) guidance

via point

via radio

combat-employable via air

via the radio

track via missile (TVM)

Sends ESC data to the FC via DShot telemetry

Configure via the Race Transponder tab after enabling

control via MSP port

Enable telemetry via switch

Executing global chip erase (via extended erase) ...

Executing local erase (via extended erase) ...

Serial (via UART)

via the Devices Firmware Upgrade mode

via its USB port or wiring up an FTDI device

Controls arbitrary output via PINIO