Enable MSP Override mode

Enable support for legacy Multiwii MSP current output

Atitude Mode (A Mode / Atti Mode )

Enable 3D mode for use with reversible ESCs

Enable BEEP GPS SATELLITE COUNT mode

Enable BEEPER ON mode

Enable Expert Mode

Enable Expert Mode options

Enable Live mode

Enable virtual connection mode

Enable gyro 32kHz sampling mode

manual override of the autoloader mechanism

override

override control

command override feature

control via MSP port

Layout mismatch, override not enabled - aborted

MCU mismatch, override not enabled - aborted

MSP connection is active with this Betaflight Configurator

MSP Sensor/OSD Slave

Multiwii Serial Protocol (MSP)

acrobatic mode (ACRO mode)

positioning mode (P Mode)

sport mode (S Mode)

attitude mode (ATTI mode)

RFMD (RF mode, Radio frequency mode)

When you enabled 3D mode in your flight controller, make sure the ESCs are also set up for 3D mode, otherwise the motors might go off with full power

enable the engine to operate

Disable/enable beeper

Disable/enable stick command

Enable advanced settings

Enable beep melody when the ESC is powered up

Enable beeping - useful for locating a crashed aircraft